Shop at SprinklerWarehouse
Click here for help choosing a controller/timer.

How to add modules to a modular irrigation controller

Most irrigation controllers are supplied with a factory-installed base module with the option to add more modules if desired. Additional modules may be added expand the controller capabilities and provide terminals for up to 15 valves total (Depending on manufacturer and model). Additional modules are sold separately and can be purchased here.


You can install optional modules in any open position in the cabinet. The valve numbers associated with each terminal (e.g. 5, 6, and 7) are molded into the cabinet.

Open the front panel and locate an open slot in the cabinet
Make sure the lever on the module is in the unlocked position (pointing to the left). Place the module in the slow between the plastic rails.
Push the module toward the top of the cabinet. Then slide the lever to the locked position (to the right).
To remove a module, slide the lever to the unlocked position and pull the module out of the slot.
You are finished!


Go to Sprinkler Warehouse Go to DIY Irrigation Tutorials
Back To Previous Page